I got free one AV modded Famicom, but when I turn the power on it doesn't give picture. But it does give strange buzzing noise...
As you can see the AV cable is hardwired:
(http://i46.tinypic.com/343syo1.jpg)
And inside it looks this:
(http://i50.tinypic.com/2rw7o86.png)
So... Is the mod probably made wrongly or could my Famicom just simply be broken? :-\
The buzz is usually for controller 2 mic,also did you try and hook it up with rf.
Quote from: Pikkon on February 05, 2013, 09:02:21 pm
The buzz is usually for controller 2 mic,also did you try and hook it up with rf.
I don't have rf switch.
buy the RF switch online, from what I have seen they are really cheap
I tested my Famicom one more time and now it did give picture, but 5 seconds later picture suddenly vanished and it started making again that annoying buzz sound.
oh
i recognized the few actual reasons of hot glued things:
1) improper wire's insulation removal. Some of copper cores damaged ugly and broken. Forgotten wire tinning.
2) bad soldering with a lot of oxidation at joints
3) very very nasty topology and component's layout design
so that non-hot glued OLOLO MOD breaks down even if you'll just breathe out on it
HELLO Drakon