I had replaced the caps on my twin famicom, but it didn't work post cap replacement. Cap replacement went pretty smoothly except the pad came up on C123 on the anode(+) side. I picked up another cheap twin famicom is hopes I might be able to figure if I missed something. It had the similar low audio with buzzing that my previous (green) twin did. Looking at the other twin (old red) I can't see where C128 goes as there is no visible trace to fallow to bridge the conection.
Where is it (C123) supposed to go?
I would prefer to rescue my green twin as the green has the turbo feature and power indicator, where as the old red one does not.
When I turn on the switch the red(power) LED and just a blank/black screen. The is not a no signal message so it's trying to do some thing.
Then when I switch over to disk I get the same thing, only I can hear a slight buzzing. Anything else I can check?
Really sorry to hear this :(
I'm going to move it to the tech help section where it should get the right eyeballs on it.
Hope you can find good help with it there...