Famicom twin 5v points?

[Lakitu]

As the title suggests I'm looking for a nice 5v point to wire in a nice on/off LED. Any suggestions?

And don't worry I'm not drilling holes in the shell, it's going to be easily removable without a trace.

Thanks y'all

[FAMICOM_87]

dude, just use a multi-meter in conductivity mode and find a best sport for the 5V and ground

[Lakitu]

Yes, thanks for that. If you read my question again I asked if anyone knew of one. I don't want to add something to somewhere that might cause issues just because I find 5v floating out one end of it. But thanks for your reply.

[Skawo]

I think this is right, though the ones with question marks may be swapped.

[Stephen]

The chips nearest the power switch need power, too. You can safely tap into their power source. Find a nearby chip, look up the data sheet for the pin out and you'll be all set.

I don't recall the switching design of the Twin Famicom, it may be possible to directly tap into the switch (though it may also be a little too spicy to conveniently tie San LED into).