fdsloadr cable

[YoshiFan501]

so i decided to crack out my tototek fdsloadr cable after i while, only to find out that pin one on the parallel port side bit the dust and is broken. any way as to how to fix it

[133MHz]

Replace the DB-25 connector, they're plentiful and cheap at any electronics store.
If the original connector is injection molded you'll have to cut it off entirely and take notes of which cable goes where.

[YoshiFan501]

ok i will try that some time
Post Merge: September 30, 2012, 06:29:08 pm
i tried that and i broke the cable
ill try a diy approach once i get a broken snes

[YoshiFan501]

ok i stripped the wire. now i need to get a pinout